The Comfort Armrest MLC 310 as X-CHANGE-SET 

available for vehicles of the manufacturers: Citroen, Dacia, Fiat, Ford, Hyundai, Kia, Mazda, Nissan, Opel, Peugeot, RAM Trucks, Renault, Subaru and Toyota.

Look in the article configurator if your vehicle is included. 

The MLC 310 model is an armrest console with a comfortable storage compartment of 1.6 liters and the dimensions 310 x 110 x 125 (WxHxD). The generous width of the Comfort Armrest MLC 310 offers comfortable relief for both driver and passenger. The maximum load capacity is 100 kg. The angle of adjustment is 60º. The lower part is made of very stable ABS, the upper part is upholstered, covered with textile and attractively sewn.

Excellent processing and optics - with ABE - manufactured in Europe
- foldable and with tilt adjustment
- easy mounting on the seat with special adapter
- Price incl. adapter / mounting material

Notes on use
(You will find information about your vehicle in the article configurator)

0.  There are no notes to be observed
1. The MLC310 armrest is not recommended to this car model.
2. The ML285 armrest is not recommended to this car model.
3. The armrest might increase on the possibility to use the storage compartment between the seats or kollide with
    the console when the seat is adjusted in its lowest position.
4. Does not fit seats with a lumbar support function (Note: some models can fit if the adjusting wheel is on the
   opposite side where the armrest is to be mounted)
5. If the seat is equipped with a side airbag -the armrest can not be mounted towards the door-side.
6. Does not fit seats original equipped with armrests or cars that have a high positioned center console that can
    collide with the armrest.
7. The lid to the storage compartment between the front seats might have to be 
    removed -can collide with the armrest.
8. Can contain difficult mounting elements that might require special tools -contact if necessary your dealer for
    advise or help.
9. The armrest can be mounted inspite of existing armrest (has to be removed before mounting).
10. Only sold as a complete set with armrest and adapter for both sides of the seat(right + left side).
11. Special adaption on separate order -the bracket is only delivered together with the armrest.
12. Fastening points must be drilled in the seatframe.
13. Can only be mounted on the driver seat if the passenger
     seat is of the type -completely foldable or a double sofa.
14. Only fit seats with a prepared fixing point for original armrests. (see mounting instruction).
15. To be able to mount armrest MLC310 -you need a minimum space of appr. 135 mm between the seats.
16. Seats equipped with the function ”a completely foldable seatback” -you will only be able to partially fold the
     seat together (approx 75%) after the armrest is attached to the seat.
17. If the seat is equipped with an adjustable backrest support -you can only use the MLC310 armrest (other
      armrest models will collide with the adj.wheel).
18. Only available at brand dealers or by special request.
19. Only for the passengerseats / backseats (not frontseats).
20. Note! older adaption.
21. If the car model has a double sofa, then only the armrest PUR355 can be mounted.
22. Use this adapter if the seat has a lumbar support funtion. Otherwise choose adapter F1030-35005R/L. 
     (is already defined in the configurator considered)
23. Use this adapter if the seat has height adjustment function (is already defined in the configurator considered)
24. By mounting armrests on the seat, the possibility of adjusting the seat down in its lowest position is limited by
      about 20% due to the armrest then colliding with the car's center

Information from the manufacturer can be found here :